INELCO C1520 Mode D'emploi page 7

SPACE HEATER 2 kW
GB
Operating Instructions
Connection
Connect space heater to mains supply through plug.
Operation
Switch on unit and start space heater by adjusting the function switch (1) to the position required
1/2 (1 kW)
1
In general
The space heater is equipped with an adjustable thermostat. The temperature required is set by means of the
adjustment button (2) after which the heater runs automatically.
WARNING !

Do not cover! Danger of fire, if the equipment is covered.

Minimum distance from inflammable materials: 0.5 m!

Do not use the heater in the immediate vicinity of washbasin, bath, shower and swimming pool!

Do not use the heater in fire hazardous rooms!

Do not use the heater outdoors in rainy weather!

Do not place the heater directly under a mains outlet!

The heater must only be disassembled by the manufactor or a qualified service engineer!

The mains cable must only be replaced by the manutactor or a qualified service engineer!
Fixed installation
When making a fixed installation the drawing must
be followed (figure 1), labels is not visible.
Maintenance
Clean the space heater with compressed air when it
is disconnected from the mains.
WARRANTY
Please apply to the store where the space heater
was bought. Remember to bring along valid receipt
or guarantee card.
1/1 (2 kW)
O
Wal
Figure 1
O
Off
MIN MAX
Ceiling
min. 0.5 m
min.
0.5 m
min. 1.8 m
Floor
Type C1520
2
min.
15 cm
Wall
7