Before Initial Use; Attaching The Handle; Insertion Of The Bottle Racks; Installation - SilverCrest SMB 140 A1 Mode D'emploi

ATTENTION! MATERIAL DAMAGE!
GB
IE
Do not transport the minibar unless it is empty. Remove all bottles before
►
transportation.
Do not place the appliance close to open fl ames or other sources of heat
►
(heating, direct sunlight, gas stoves, etc.).
Never place the appliance in a built-in cupboard, recesses or similar.
►

Before initial use

Take the appliance out of the box and remove the
packaging material and any stickers.

Attaching the handle

1) Open the door 0.
2) Hold the handle q in front of the holes with
the pre-inserted screws on the left-hand side
of the door.
3) Push the seal 9 to one side over the holes and
screw in the screws using a Phillips screwdriver.
4) Slide the seal 9 back into the correct position
and press it fi rmly into place as required.
NOTE
Ensure that the seal 9 sits fi rmly in the door
►
frame and the door closes correctly.

Insertion of the bottle racks

■ Push the bottle rack onto the guide rails so that
the tabs on the bottle rail rest on the rear part
of the rails.

Installation

ATTENTION! MATERIAL DAMAGE!
► Ensure that the ventilation grille is not covered
when the appliance is in use. Risk of over-
heating! Maintain a clear distance of at least
15 cm between the ventilation grilles and
other objects.
4
■ Place the appliance on a clean and level surface.
■ If the appliance is slightly unstable, you can
compensate for any unevenness of the surface
upon which it has been placed by means of
calibration of the adjustable feet w. To do this,
turn the relevant adjustable feet w until the ap-
pliance is stable.

Bottle sizes

This minibar is designed for standard commercial
drink bottles with a maximum length of approximately
31 cm.
Longer bottles can be stood upright in the minibar.
To do this, remove the lower bottle racks.
If a large bottle, for example, a champagne bottle,
does not fi t between the bottle racks due to its
diameter, remove the bottle rack above the bottle.

Inserting/removing the bottles

■ To insert bottles into the appliance, pull the
bottle racks out of the appliance until the tabs
stop the bottle racks from moving further along
the guide rail.
■ Then place the bottles on the bottle rack.
■ Push the bottle rack back into the appliance.
■ To remove bottles from the appliance, pull the
respective bottle rack out of the appliance until
the tabs stop the bottle rack from moving further
along the guide rail.
■ Remove the bottle and slide the bottle rack back in.
SMB 140 A1