J5create JUC500 Manuel De L'utilisateur page 5

WORMHOLE SWITCH
WORMHOLE SWITCH
Windows installation
Please follow the instructions below to install the wormhole switch driver.
1. Connect one end of the wormhole switch to a standard USB port on one of the two
computers. And connect the other end of the wormhole switch to a USB port on the second
computer.
2. The device will automatically start the wormhole switch software installation on both
computers. An AutoPlay option window may appear. Please double-click the wormhole icon
to start the application.
3. If the User Account Control window appears on the screen, click Yes to continue.
4. Please run the steps above on both computers. If the other computer is a Mac, please refer to
the Mac installation guide.
5. When the wormhole switch is connected properly the wormhole launch page will be shown.
The wormhole switch icon will appear in the lower right-hand corner. If the two units are
connected to the USB3.0 port
USB3.0; however, if a USB2.0 port is connected to one end, then this
indicating that the transmission speed is USB2.0.If the
computer is not connected.
6. Please set the position of the other PC. Please click on the wormhole switch
to open the wormhole switch toolbar. Then click on The Position of Other PC and select the
screen location according to where you want your mouse to flow from one screen to the
other.
this icon will appear, indicating the transmission speed as
5
3
USER MANUAL
USER MANUAL
icon will appear,
icon appears it means the other
or
EN
icon