Operation - Bosch BRC3600 Notice D'utilisation D'origine

English – 8
Intended use
The LED Remote control unit is designed to control a
Bosch eBike system and control an on-board com-
puter.
The eBike Flow app can be accessed via Bluetooth®.
Technical data
Control unit
Product code
Max. charging current of USB
port
USB port charging voltage
A)
USB charging cable
Charging temperature
Operating temperature
Prerequisites
The eBike system can only be activated when the fol-
lowing requirements are met:
– A sufficiently charged battery is inserted (see bat-
tery operating instructions).
– The speed sensor is connected properly (see drive
unit operating instructions).
Control unit power supply
If a sufficiently charged eBike battery is inserted into
the eBike and the eBike system is switched on, then
the control unit battery is powered and charged by
the eBike battery.
If the state of charge of the internal battery is very
low, you can charge the internal battery via the diag-
nostics connection (7) with a USB Type C® cable us-
ing a power bank or another suitable power source
(charging voltage 5 V; charging current
max. 600 mA).
Always close the flap of the diagnostics connec-
tion (7) so that no dust or moisture can enter.
0 275 U07 3RL | (09.07.2021)
LED Remote
BRC3600
mA 600
V 5
B)
USB Type‑C®
°F 32 to 104
°F 23 to 104

Operation

Control unit
Storage temperature
Diagnostic interface
Internal lithium-ion battery
Protection rating
Dimensions (without fasten-
ing)
Weight
Bluetooth® Low Energy 5.0
– Frequency
– Transmission power
A) Not included as part of standard delivery
B) USB Type-C® and USB-C® are trademarks of USB Imple-
menters Forum.
Switching the eBike system on/off
To switch on the eBike system, briefly press the on/
off button (1). After all LEDs briefly light up, the state
of charge of the battery is displayed in color with the
battery charge indicator (3) and the set assistance
level with the (5) display. The eBike is ready to ride.
The display brightness is controlled by the ambient
light sensor (12). Therefore, do not cover the ambi-
ent light sensor (12).
The drive is activated as soon as you start pedaling
(except at assistance level OFF). The motor output
depends on the settings of the assistance level.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
20 mph, the eBike drive unit switches off the assis-
tance. The drive is automatically re-activated as soon
you start pedaling again and the speed is below
20 mph.
To switch off the eBike system, press the on/off but-
ton (1) briefly (< 3 s). The battery charge indica-
tor (3) and the assistance level LED (5) go out.
If no power is drawn from the eBike drive for
about 10 minutes (e.g. because the eBike is not mov-
LED Remote
°F 50 to 104
B)
USB Type‑C®
V 3.7
mAh 75
IP54
mm 74 × 53 × 35
oz 1
MHz 2400–2480
mW 1
Bosch eBike Systems