Publicité
Les langues disponibles
Les langues disponibles
SDF-126339.5 / SDF-126339.6
TRANSPORT AND PACKAGING
Transport the appliance
Transport the appliance, if possible, in vertical position. Otherwise, it is absolutely necessary to allow the
appliance standing upright for four hours before installation "Prior to first use". Protect the appliance during
transport against weather influences.
Unpacking the appliance
Remove the appliance from its packaging.
To prevent hazards, check the appliance for any transport damage.
NOTE: Production residue or dust may have collected on the appliance. We recommend cleaning the appliance
according to chapter "Cleaning and Maintenance".
APPLIANCE EQUIPMENT
Appliance overview
1.
Temperature control
2.
Freezing compartment
3.
Levelling feet
4.
Freezer door
INSTALLATION
Conditions for the installation location
Good ventilation is required around the appliance to dissipate the heat properly and to guarantee efficient
cooling operation at low power consumption. Enough clearance is necessary.
-
Gap to the back approx. 50-70 mm, to the side walls each approx. 100 mm;
-
Place the appliance so that the appliance door can open without being impeded.
Only install at a location with an ambient temperature suitable for the climate class of the appliance. The
climate class can be found under "TECHNICAL SPECIFICATIONS".
Place the appliance on a steady and safe surface. If the appliance is not horizontally leveled, adjust the
feet accordingly.
Avoid the installation:
-
near heaters, next to a stove, direct sunlight or any other heat sources;
-
at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be susceptible to
corrosion under such circumstances;
-
near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.), in rooms which may have poor
air circulation (e.g. garages).
-
Do not expose the appliance to any weather.
- 6 -
EN
Publicité
