Olympus PPO-E02 Mode D'emploi page 13

3 Dismounting the PPO-E02
CAUTION:･ While dismounting the PPO-E02 from the case, water remaining on the PPO-E02 may splat-
ter on the lens or camera. If this happens, wipe the water off the lens and camera with a dry
cloth.
･ Make sure that the port is completely dry before dismounting.
If any water is on the product, wipe it completely away and
make sure that the product is dry.
Holding the PT-E series case firmly with one hand, loosen the
PPO-E02 by turning it about 90 degrees counterclockwise. If
the PPO-E02 is attached too tightly to turn, wrap it with a piece
of rubber or similar non-slip material.
After loosening the PPO-E02, point its lens downward and
turn it further counterclockwise until it is separated from the
PT-E series case. Be careful not to drop the PPO-E02 or
PT-E series case.
E-3