Publicité
Les langues disponibles
Les langues disponibles
Ice-Dispenser Anleitung
6. Clean the outside of the ice maker regularly with a mild detergent solution and warm water.
7. Dry the interior and exterior with a soft cloth. How to drain all the water from both the water rese
voir and ice storage compartment
1. Power should be off and unit unplugged.
2. Place the icemaker in a position where water can be collected from the drain.
3. Remove water drip tray/cup-glass holder to access drain. (see image below)
4. Remove drain plug and let water flow out. (see image below)
5. Replace drain plug and clean the water reservoir and ice storage compartment with diluted vinegar
solution.
6. Use water to rinse the water reservoir and ice storage
compartment.
7. Remove drain plug and let water flow out.
8. Replace drain plug and dry water reservoir and ice
storage compartment with soft cloth.
9. Store ice maker in dry, clean area.
NOTE: When moving the unit, it is better to allow the
refrigerant liquid inside the compressor to settle at least
3 minutes before restarting.
TROUBlESHOOTING GUIDE
PROBLEM
Power LED indicator
will not come on
"Ice Full" LED
indicator is on
Ice cubes in storage
compartment but
do not come out the
dispenser
"Add Water" LED
indicator is on
Ice making cycle is
normal but no ice is made
Solid block of ice
forms on evaporator
14.05.2010 12:47 Uhr
POSSIBLE CAUSES
Plug disconnected from
wall outlet
Storage compartment is full
Auger in ice storage
compartment is blocked
Auger in ice storage
compartment is blocked
Water reservoir is empty or
water level is low
Ambient temperature or
water temperature inside
reservoir is to high
Refrigerant liquid leakage.
Pipe in the cooling system
is blocked.
Ice dispensing not complete
from storage compartment
Seite 13
Remove
the Water
drip tray
Unplug the drain cap
SOLUTION
Check that unit is plugged into
standard 120V, 60 Hz outlet.
Also make sure outlet has power
and circuit breaker is not tripped.
Remove ice from storage
compartment via the dispenser
Close hatch securely, resetting
safety switch and reactivating
auger
Release ice dispenser paddle,
wait 10 seconds, push ice
dispenser paddle forward again
Use provided funnel to add
water to reservoir on side of unit.
Operate ice makers at ambient
temperature below 90º and pour
colder water into reservoir.
Turn power off, unplug unit
and contact a qualified technician.
Turn power off, unplug unit
and contact a qualified technician.
Unplug and allow ice to melt
(never use sharp object to
remove ice).
Publicité
