Sistec MT+ Manuel D'utilisation page 11

Congratulations on your purchase of this Sistec quality product.
Please read this manual carefully before use.
I. Precautions
- Place your safe in a dry area only.
- Store your personal code in a secure place.
II. Fixing
For optimum safety, it is recommended to fi x the Sistec MT+ on a concrete fl oor.
Please use the supplied fi xing hardware (see fi gure 1). In any other cases please ask your dealer
about fi xing material
Always anchor the safe with two anchor bolts.
• Choose a suitable and appropriate space to place your safe.
• Place the safe on the exact spot where you want to fi x the safe.
• Check if the door opens and closes smoothly.
• Remove the shelf and remove the cap from the fi xing hole.
• Mark the drilling location on the fl oor through the fi xing hole.
• Move the safe and drill a hole in the fl oor with a diameter of 12 mm and a depth of
approximately 90 mm.
• Remove the dust from the drilling hole and clean the fl oor.
• Put the fi xing hole of the safe on the drilling hole.
• Put the fi xing bolt in the fi xing hole and use a hammer to put it deeper.
• Tighten the nut and washer securely with a suitable spanner.
• Check to ensure the safe is fi xed.
* Alternative fixing material for Sistec MT+ safes:
M10x30 class 8.8 impact anchor Ø12x40
M10x70 class 8.8 chemical anchor
(diameter 12mm) suitable for your fl oor type.
*
Figure 1: fi xing bolt Ø12
think safe
11