Symbols - Rigid R4141 Manuel D'utilisation

356 mm (14 po) tronçonneuse abrasive
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SyMBOLS

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SyMBOL
SIGNAL
DANGER:
WARNING:
CAUTION:
CAUTION:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SyMBOL
Safety Alert
V
Volts
A
Amperes
Hz
Hertz
min
Minutes
Alternating Current
n o
No Load Speed
Class II Tool
.../min
Per Minute
Wet Conditions Alert
Read The Operator's Manual
Eye Protection
No Hands Symbol
Hot Surface
MEANING
Indicates an imminently hazardous situation, which, if not avoided, will result
in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, could result
in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in
minor or moderate injury.
(Without Safety Alert Symbol) Indicates a situation that may result in property
damage.
NAME
Indicates a potential personal injury hazard.
Voltage
Current
Frequency (cycles per second)
Time
Type of current
Rotational speed, at no load
Double-insulated construction
Revolutions, strokes, surface speed, orbits etc., per minute
Do not expose to rain or use in damp locations.
To reduce the risk of injury, user must read and understand
operator's manual before using this product.
Always wear safety goggles or safety glasses with side shields and,
as necessary, a full face shield when operating this product.
Failure to keep your hands away from the blade will result in serious
personal injury.
To reduce the risk of injury or damage, avoid contact with any hot
surface.
6 - English
DESIGNATION/ExPLANATION

Publicité

Table des Matières
loading

Table des Matières