Hama SIRIUM3800ABT Notice D'utilisation page 10

8. Connection via Auxiliary Input / Line In
You can use the analogue audio inputs (Line In / AUX) to
connect mobile devices (for example, smartphone, tablet
PC, MP3 player, etc.) and older analogue sources (CD/DVD
player etc.) to the soundbar and play their audio signals
using the soundbar. For the connection, you can use either
a 3.5-mm audio cable (jack cable) or an RCA cable.
Note
• Switch off the soundbar before connecting a terminal
device.
• Do not bend or crush the cable.
• For playback using the LINE In connection, connect your
terminal device to the soundbar using the LINE In socket
(1) and an RCA cable, and select the LINE In mode.
• For playback using the AUX connection, connect your
terminal device to the soundbar using the AUX socket
(2) and a 3.5-mm audio cable (jack cable), and select
the AUX mode.
• Press [POWER] (1) to switch on the soundbar.
• Activate the Line In or AUX mode by repeatedly pressing
the [MODE] button (2) on the soundbar.
• The AUX/Line In status LED (9) is lit red if the LINE IN
mode was selected, blue if the AUX mode was selected.
• Alternatively, press [AUX] (12) on the remote control for
a connection using a 3.5-mm audio cable (jack cable), or
[LINE In] (11) for a connection using an RCA cable.
9. Connection via optical/coaxial input
You can use the soundbar's digital audio inputs to connect
your terminal device (for example, TV set) and play its
audio signals using the soundbar For the connection, you
can use either an optical signal cable or a coaxial cable.
Note
• Switch off the soundbar before connecting a terminal
device.
• Remove the protective caps from both ends of the
optical signal cable before connection.
• Do not bend or crush the cable.
6
• For playback using the optical audio input, connect one
end of the optical signal cable (supplied) to the optical
audio input (4) on the soundbar, the other end to the
optical audio output on your terminal device; then select
the Optical mode.
• For playback using the coaxial audio input, connect one
end of a coaxial cable to the coaxial audio input (3) on
the soundbar, the other end to the coaxial audio output
on your terminal device; then select the Coaxial mode.
• Press and hold [POWER] (1) for about 3 seconds to
switch on the soundbar.
• Activate the Optical or Coaxial mode by repeatedly
pressing the [MODE] button (2) on the soundbar.
• The Optical/Coaxial status LED (8) is lit blue if the
Optical mode was selected, red if the Coaxial mode was
selected.
• Alternatively, press [Optical In] (16) on the remote
control for a connection using an optical signal cable, or
[Coax In] (10) for a connection using a coaxial cable.
10. Care and Maintenance
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
• If you do not use the product for a long time, turn off
the device and disconnect it from the power supply.
Store it in a clean, dry place out of direct sunlight.
11. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety
notes.
12. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
The complete instruction manual is available at:
www.hama.com -> 00054852 -> Downloads