LIST OF CODE REGISTERS
The programming codes of telephones/monitors, the call codes and the door-opening codes
pertaining to each dwelling are stored in the list of code registers. Each register consists of
3 codes pertaining to a single dwelling.
The programming code is the internal code which the panel will send through the BUS
connection to call the telephone/monitor in the dwelling.
The call code is the code that the visitor must enter in order to call to the dwelling.
The door-opening code is the code that the visitor enters in order to open the door.
If you wish to assign call codes which are different from the programming codes, turn on the
Call code option in the entrance panel (see the datasheet of the entrance panel with keypad).
Note: For a register to be valid, you must enter at least the programming code and the call
code.
HOW TO CREATE A NEW REGISTER IN THE LIST OF CODE REGISTERS
To create a new element in the list of code registers, press the Add button (
in the codes in the code fields (29). Then press the OK button (
the changes. If the register is incorrect, an error message (34) will be displayed.
HOW TO MODIFY A REGISTER IN THE LIST OF CODE REGISTERS
HOW TO DELETE A REGISTER IN THE LIST OF CODE REGISTERS
To delete a register, select it in the list by left-clicking on it with the mouse. Next, press the
Delete button (
). The element will immediately be deleted.
Important: This action cannot be undone:
elements deleted from the list cannot be
recovered. Be particularly careful, therefore,
when using this feature.
). Next, type
) to confirm and to save