Publicité
Les langues disponibles
Les langues disponibles
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is
recommended that you should clean your kettle
before use by boiling a full kettle of water twice and
then discarding the water. Wipe the surface with a
damp cloth.
NOTE: the max capacity of kettle is 1.5L.
OPERATION OF YOUR KETTLE
1. To fill the kettle, remove it from the power base
and open the lid by pulling backwards and lifting lid
handle, fill with the desired amount of water, and
then close the lid. Alternatively, the kettle may be
filled through the spout. The water level should not
exceed MAX marks or sit below MIN level. Too little
water will result in the kettle switching off before
the water has boiled.
NOTE: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Turn on
the switch by pressing it, the indicator will light up.
Then start to boil the water, the kettle will switch
off automatically once the water has boiled. You
can shut off the power by turning off the switch
at any moment during boiling water. If you want to
boil water again, only turn on the switch directly to
restart the kettle.
NOTE: Ensure that switch is free of obstructions
and the lid is firmly closed, the kettle will not
turn off if the switch is constrained or if the lid is
opening.
4. Lift the kettle from the power base and then
pour the water.
NOTE: operate carefully when pouring the water
from your kettle, as boiling water will scald.
5. The kettle will not re-boil until the switch is
pressed again. The kettle may be stored on the
power base when not in use.
Note: always disconnect the power supply when
not use.
WARNING: Do not remove the lid while the water
is boiling.
CAUTION: Position the lid so that steam is
directed away from the handle.
CAUTION: Should you accidentally let the kettle
operate without water, the boil-dry protection will
automatically switch off the power. If this occurs,
allow the kettle to cool before filling with cold
water before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power
outlet before cleaning.
1. Never immerse the kettle, power cord or power
base in water, or allow moisture to contact with
these parts.
2. Wipe the appearance of body with a damp cloth
or cleaner, never use a poisonous cleaner.
3. Remember to clean the filter at intervals. For
easier cleaning, detach the filter and then replace it
after cleaning.
CAUTION: Do not use chemical, steel, wooden
or abrasive cleaners to clean the outside of the
kettle to prevent the gloss loss.
4. When not use or storage, the power cord may be
wound under the bottom of kettle.
5. Your kettle should be periodically descaled as the
mineral deposits in tap water may form scale on the
bottom of kettle so as to cause the operation less
efficiency. You can use the commercially available
descaler and follow the instructions on the package
of descaler. Alternatively, you may follow below
instructions using the white vinegar.
1. Fill the kettle with 3 cups of white vinegar, then
adding water to the amount so as to cover the
bottom of kettle completely. Leave the solution in
the kettle overnight.
2. Then discard the mixture in the kettle, then
filling the kettle with clean water, boiling and then
discard the water. Repeat several times until the
odor of vinegar has been flushes away. Any stains
remaining inside the spout can be removed by
rubbing with a damp cloth.
10
EN
Publicité
