Oregon DS6639 Mode D'emploi page 20

FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Oregon Scientific, Inc.
19861 SW 95th Place
Tualatin, Oregon 97062, USA
Tel: 800-853-8883
Fax: 503-684-8883 FOR HOME OR OFFICE USE
Caution:
Modification
The FCC requires the user to be notified that any changes or modifications made to
this device that are not expressly approved by Oregon Scientific, Inc. may void the
user's authority to operate the equipment.
Interface cable
Use the shielded cable sold or provided by Oregon Scientific, Inc. for your equipment.
Using other interface cable may exceed the limits of Class B Part 15 of the FCC rules.
34
DS6639 Manual-Eng/Fre/Span (086-003300-060)
Tested To Comply
With FCC Standards