Operation Guide; Replacement Of Batteries In Remote Controller - TOSOT TW09HQ1B2DI Manuel Du Propriétaire

Function introduction for combination buttons
will automatically adjust the indoor temperature according to the detected tempera-
ture. Press this two buttons simultaneously again to close I FEEL function and "
will disappear.
● Please put the remote controller near user when this function is set. Do not put
the remote controller near the object of high temperature o r low temperature in
order to avoid detecting inaccurate ambient temperature.When I FEEL function
is turned on, the remote controller should be put within the area where indoor
unit can receive the signal sent by the remote controller.

Operation guide

After putting through the power, press "ON/OFF" button on remote controller to
1.
turn on the air conditioner.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
2.
HEAT.
Press "▲" or "
3.
Press "FAN" button to set your required fan speed: auto, low, medium and high
4.
speed.
Press "SWING" button to select fan blowing angle.
5.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
with " ", as shown in the fig, and then push out
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal sender at the receiving
window on indoor unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during
operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there's no display, please
replace batteries.
" button to set your required temperature.
18
signal sender battery
reinstall
remove
Cover of battery box
"