Mac Usb Driver And Musicmatch™ Software Installation - Archos Jukebox Studio Guide D'installation

Battery Shows remaining power in 4 levels.
Play/Pause in Audio mode. Lit when plays, or blinks when paused. In
Play
Browser mode, the icon is turned off.
In Audio Mode, Stops playing or hold for 3 sec to turn off. In Browser
Stop
and Menu modes, icon is lit.
Fwd/Bwd In Audio Mode, icon blinks in Fast Forward or Fast Reverse;
otherwise, it is not showed.
Indicates low and high sound in 6 levels.
Volume
On when the Jukebox is connected to the computer via the USB
USB
cable. Note: Other functions are not available when USB cable is
connected.
On when in Audio mode, and off otherwise.
AUDIO
On when in Menu mode and off otherwise.
PARAM
MAC USB Driver and MusicMatch™ Software Installation
Connecting Jukebox to MAC & Uploading MP3 Tracks
MAC USB Driver Installation
•
Turn on your computer and wait until it has finished booting.
•
Gently connect one end of the USB cable to the Jukebox.
•
Turn on the Jukebox. ARCHOS power adaptor may be required if there isn't enough power
from the batteries.
•
Connect the other end of the USB cable to a free USB port on your computer.
•
Insert the included software CD into your CDROM drive
•
Double click on the software CD shows on your computer desktop
•
Double click on the ARCHOS USB Driver Installer
•
Follow the on-screen instructions, then Restart your computer
•
You should recognize an additional hard disk icon displayed on the desktop
•
Drag and Drop MP3 tracks to Jukebox Drive
•
Disconnect the USB cable on both ends, and play the MP3 tracks
Note : Your Mac system will recognize the Jukebox hard disk automatically if you have
PC Exchange Installed. If not, you will have to re-format the Jukebox hard disk
for Mac to recognize. To format, highlight the New Recognized Hard Disk and
click on Erase Disk under "Special" Mac Menu. MAC disk utilities may be
required to partition the hard disk in some cases.
- 11 -