Cutting 45-Degree Worktop Joints; Cutting The Worktop Joint Clamp Recesses - CMT ORANGE TOOLS CMT650 Manuel D'utilisation

Cutting 45-degree worktop joints...

C
D

Cutting the worktop joint clamp recesses...

To cut the clamp recesses, fit two stops in the jig holes D. The positioning of the clamps should be no
less than 100mm in from the front edge of the worktop. However the spacing between them can be as
on the jig or altered to suit the worktop width. Remember to match them on both adjoining sections
of worktop, setting-off from the front edge by measuring or transfer batten.
Butt the stops against the joint edge and clamp it firmly. Cut the recesses to a depth so that the clamp
bolt is approximately centred on the thickness of the worktop. The same 30mm guide bush and 12mm
cutter is used for this operation, cutting in a series of shallow passes and taking out all of the waste
from the recess.
www.cmtutensili.com
13