Troubleshooting - Dometic PERFECTVIEW VT100WiFi Instructions De Montage Et De Service

VT100WiFi
When connected to the reversing light
➤ Switch on the vehicle's ignition.
➤ Engage the reverse gear of the vehicle.
✓ 6 – 8 seconds after engaging in reverse gear, the transmitter is ready for operation.
➤ Connect your receiving device to the wireless network of the transmitter. Use the address and
the password to do this, which can be found on the transmitter housing.
➤ Start the VT100WiFi app on your receiving device.
✓ The receiving device displays the camera image.
✓ After three seconds without further action, the receiving device switches to full-screen mode.
✓ Double-click on the screen to open the control bar.
9

Troubleshooting

Problem
The receiving device
cannot find the
transmitter's wireless
network.
The transmitter's
operating display does
not light up.
The app on the receiving
device has a black
screen.
The app on the receiving
device has a blue screen
but the receiving device
is connected to the
wireless network of the
transmitter.
The receiving device cuts
off during image play-
back and displays a
yellow warning triangle.
EN
Cause
The transmitter does not
work.
The transmitter does not
work.
The green cable is not
connected correctly.
The transmitter is not
receiving a video signal.
The connection between
transmitter and receiving
device is too weak.
Suggested remedy
Check the power supply.
Check whether the app responds:
open the control bar by double-
clicking on the screen.
Check the transmitter connection and
function.
Check the camera connection and
function.
Make sure that the antenna of the
transmitter is connected properly.
Check if the vehicle battery is charged
sufficiently.
Troubleshooting
15