Introduction; Layout; Scope Of Delivery; Intended Use - Bamato WORK-550 Traduction Des Instructions D'origine

1. Introduction

Manufacturer:
Markmüller Maschinen GmbH
Gewerbepark Garham 10
94544 Hofkirchen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
Improper handling,
•
Non-compliance of the operating instructions,
•
Repairs by third parties, not by authorized service
•
technicians,
• Installation and replacement of non-original spare
parts,
Application other than specified.
•
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its informa-
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety notices contained in this
operating manual and the particular instructions for
your country, the generally recognised technical reg-
ulations for the operation of identical devices must
be complied with.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

2. Layout

1. Handle
2. Key
3. Spray can holder
4. Document holder
5. Castor
6. Castor with brake
7. Fixed wheel
8. Litter bins
9. Paper holder
10. Sealing cap
11. Rear panel
12. Guide rail
13. Partition

3. Scope of delivery

• Workshop trolley
• Castor
• Castor with brake
• Fixed wheels
• Fastening screws
• Key
• Spray can holder
• Document holder
• Litter bins
• Paper holder
• Rear panel
• Guide rail
• Partition
• Operating Manual

4. Intended use

The trolley is designed solely for the storing of tools
with a maximum load of 450 kg. It is solely intended
for private use indoors and is not suitable for com-
mercial applications.
Only use the trolley as described in this operating
manual. Any other use is considered unintended use
and can lead to damage or even injury. The trolley is
not a toy.
The manufacturer or dealer assumes no liability for
damage caused by unintended or improper use.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the equipment is used in
commercial, trade or industrial businesses or for equiv-
alent purposes.
GB | 11