Baofeng UV-5R Série Mode D'emploi page 20

Menu Name (Full Name) Setting
25 SFT-D - Frequency OFF [0]: TX = RX (simplex)
Shift Direction
+[1]: TX will be shifted higher in
frequency than RX frequency.
-[2]: TX will be shifted lower in
frequency than RX frequency.
26 OFFSET - 00.000-69.990 in 10 kHz
Frequency Shift steps
amount
27 MEM-CH – Store 000-127
a Memory
Channel
28 DEL-CH-Delete a 000-127
memory channel
29 WT-LED - Display OFF [0] | BLUE [1] |
backlight color, ORANGE [2] | PURPLE [3]
Wait/Standby
30 RX-LED - Display OFF [0] | BLUE [1] |
ORANGE [2] | PURPLE [3]
backlight color-
Receive
33
Description
Enables access of repeaters in VFO/ Frequency
Mode.
Specifies the difference between the TX and RX
frequencies. The RX frequency is the base and
the amount set here will be the offset frequency
for the TX frequency.
This menu is used to either create new or modify
existing channels (0 through 127) so that they
can be accessed from MR/Channel Mode.
This menu is used to delete the programmed
information from the specified channel
(0 through 127) so that it can either be
programmed again or be left empty.
Default: PURPLE
Default: BLUE
Menu Name (Full Name) Setting
31 TX-LED - Display OFF [0] | BLUE [1] |
backlight color- ORANGE [2] | PURPLE [3]
Transmit
32 AL-MOD – Alarm SITE [0]: Sounds alarm
Mode through your radio speaker
only
TONE [1]: Transmits a cycling
tone over-the-air
CODE [2]: Transmits '119' (911
in reverse?) followed by the
ANI code over-the-air
33 BAND UHF or VHF
34 TDR-AB –Transmit OFF [0] | A [1] | B [2]
selection while in
Dual Watch mode
35 STE - Squelch OFF [0] | ON [1]
Tail Elimination
34
Description
Default: ORANGE
SITE: Sounds alarm through your radio speaker
only
TONE: Transmits a cycling tone over-the-air
CODE: Transmits '119'（911 in reverse?)
followed by the ANI code programmed by
computer software over-the-air
Displays the Band of the current displayed
frequency on the Upper A or Lower B LCD
display.
When enabled, transmit priority is set to
selected LCD display A or B once the received
signal in the other A or B display disappears.
This function is used eliminate squelch tail noise
between Baofeng handhelds that are
communicating directly (no repeater).
Reception of a 55 Hz or 134.4 Hz tone burst
mutes the audio long enough to prevent hearing
any squelch tail noise.