Velleman SHE9 Notice D'emploi page 11

• Clean any dirt on the cuff with a moistened cloth and some soap.
• Never use too much water.
• Do not bend the cuff or sleeve. Wrap the inside to the outside.
• Do not dismantle the unit, remove the cuff or try to repair yourself. Contact your distributor.
• Do not operate the unit under severe climatic circumstances or at extreme temperatures,
humidity or direct sunlight.
18. Troubleshooting and Error Messages
Trouble/Error
No indication when powered
on
Err 0
Err 1
Err 2
Err 3
Err 4
Err 5
Err 6
Err 7
SHE9
Possible Cause
• Batteries are not properly
installed
• Drained batteries
• No pulse or detected pulse
too low
• Cuff is leaking air or
inflation is too slow
• Cannot measure systolic
• Cuff pressure is too high
• Cannot measure systolic
or is outside of range
• Deflation is too fast
• Deflation is too fast
• Systolic is outside of range
11
Solution
• Check the polarity of the
batteries
• Remove the batteries and
wait 10 seconds before
reinstalling
• Refit the cuff and repeat
the measurement
• Replace the batteries or
contact your distributor
• Refit the cuff and repeat
the measurement
• Refit the cuff and repeat
the measurement
• Refit the cuff and repeat
the measurement
• Contact your distributor
• Contact your distributor
• Refit the cuff and repeat
the measurement
VELLEMAN