bester 155-ST Manuel D'utilisation page 8

Output Connections and Front Panel Controls
A quick disconnect system using Twist-Mate
connections. Refer to the following sections for more information on connecting the machine for
operation of stick welding (MMA) or TIG welding.

(+) Positive Quick Disconnect: Positive output connector for the welding circuit.

(-) Negative Quick Disconnect: Negative output connector for the welding circuit.
Bester 155-ST
1 – Carrying handle, 2 – Power ON/OFF LED, 3 – Thermal LED, 4 – Positive output,
5 – Negative output, 6 – Output current control, 7- TIG Lift/Stick switch, 8 – ON/OFF Switch
Output Current Knob: Potentiometer used to set the output current used during
welding.
Power ON/OFF LED: This LED lights up when the machine is ON.
Thermal LED: This indicator will turn on when the machine is overheated and the
output has been disabled. This normally occurs when the duty cycle of the machine
has been exceeded. Leave the machine on to allow the internal components to
cool. When the indicator turns off, normal operation is again possible.
Maintenance
For any maintenance or repair operations it is recommended to contact the nearest technical
service center or Lincoln Electric Bester Sp. z o.o.
unauthorized service centers or personnel will null and void the manufacturers warranty.
Mains supply network must be disconnected from the machine before each maintenance and
service. After each repair, perform proper tests to ensure safety.
Operation
See chapter: Quick Start
TM
cable plugs is used for the welding cable
Bester 170D-ST / 210D-ST
9 – Digital display
WARNING
WARNING
Back view
Maintenance or repairs performed by