Hkoenig WXT400 Manuel D'utilisation page 5

• Use this appliance only as described in this manual. Any
other use is not recommended by the manufacturer and
may cause fire, electric shock or injury.
• Do not use abrasive cleaning products on this appliance.
Clean with a damp cloth (not wet) rinsed in hot soapy
water only. Always remove plug from the mains supply
before cleaning.
• Socket-outlet should not be located at the back of the
heater. They should be located outside the physical
footprint of the units to minimize heat build-up behind the
heater.
• The heater is to be installed so that switches and other
controls cannot be touched by a person in the bath or
shower.
• Do not connect the appliance to the mains source until it
has been installed in its final location and adjusted to the
position it will be used in.
• Do not operate with the cord coiled up as this could
cause a buildup of heat, which could pose a hazard.
The use of an extension cord with this appliance is not
•
recommended.
• Do not allow cord to come in contact with heated
surfaces during operation.