König Electronic CMP-PSUP350RW Mode D'emploi page 2

Installation instructions
1. Disconnect the computer from the main power source.
2. Remove the case/cover from your PC system.
3. Unplug all power connectors from the old power supply.
4. Remove the four screws from the rear of the case that hold the old power supply to the
chassis.
5. Place the new power supply and screw the four screws into the rear of the case that
hold the power supply to the chassis.
6. Reconnect all power connectors from the König power supply to the computer
components. The plugs will only fit one way, so if they don't fit, do not try to force them.
Just try the other way round.
7. Ensure no screws remain loose inside the casing as these could potentially short-circuit
your motherboard.
8. Replace the case/cover.
Description of the connectors
ATX 20+4 connector with 4 pin connector separated
ATX12V 4+4 connector combined (left picture) and separated (right picture)
ENGLISH
(left picture) and attached (right picture)
2