Access To The Web Interface - INFOSEC CS141-MINI Guide D'installation Rapide

1. Access to the web interface

As mentioned before, the card arrives with a default configuration that has the IP address 10.10.10.10. It is advisable
to change this IP address and put a corresponding one to your infrastructure in
account, but is not recommended. If the DHCP service fails, there are many implications.
1.1. Add the route
1. Connect the CS141 card using an RJ45 cable directly
on a computer, configured with a static IP.
2.
Open a DOS command
as administrator.
3.
Enter the following command to access the web interface
of the card:
"route add 10.10.10.10 <local IP Address>"
(Example: "route add 10.10.10.10 192.168.222.54")
4.
Execute the command ''
device is accessible.
➔ The CS141 needs about 30 seconds to start its web server.
➔ When the web server is running, the diode changes color
from red to green (start) and starts blinking.
2. Access via an HTTP connection and login
1.
Start a Browser
2.
Enter the address http://10.10.10.10
3.
For the login, enter the
default credentials:
Username: admin
Default password: cs141-snmp
or run the command ''
ping 10.10.10.10 '' to check if the
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany
All rights reserved - v.: 3.1.0 2019-08-14 /CS141 - FW1.74-1.80
INFOSEC UPS SYSTEM – 15, rue du Moulin – 44880 SAUTRON - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 12 19 AA AA 203 06
cmd.exe ''
static mode. DHCP mode is taken into
9