EIBENSTOCK Automix 1801 Notice Originale page 13

Technical Data
Automix 1801
Nominal voltage
Power drain
Rated current
Order No.
Frequency:
Rated speed
Batches up to:
Stirrer holder:
Protection class:
Degree of protection:
Weight:
Interference suppression:
Stirrer with stand, bucket, stirrer basket, protective shield and operation
manual in cardboard box.
Intended Use
The Automix 1801 tool is intended be used to prepare and mix ready-
mixed plaster, mortar and concrete as well as gypsum, lime and other
building materials of medium to high viscosity and a maximum quantity of
50 kg.
General Instructions
The tool may be used only together with the stand supplied along with it.
The tool's working spindle is equipped with a M20 female thread.
Thread and front surfaces must be kept clean.
When assemble the stirring rod put the ring supplied along with the tool
between spindle and stirring rod to simplify the removal of the stirring rod.
The stirrer basket should be detached using a SW 27 open-end wrench.
Supply
230 V ~
1500 W
7,0 A
07614
50 - 60 Hz
50 rpm
50 kg
M 20, female thread
II
IP 20
approx. 26.5 kg
acc. to: EN 55014 and EN 61000
13
110 V ~
1400 W
13,3 A
07615 / 07616