– Z.A
1074, A
C
VENUE DES
ARRIERES
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - e-mail : accueil@ermax.fr
Fitting kit
- 1 ABS dashboard
- 3 rubber inserts M5
- 5 screws BHc 5×15 (big head)
- 3 plastic washers Ø5
Fitting instructions
- Remove the upper cover of the meter and place the
rubber insert with the wide collar like shown on the
photo: pass it through the inside and if necessary cut out
pieces as indicated by the dotted lines on the picture.
- Place the ABS dashboard and fit it thanks to 2 screws
BHc 5×15 for the original fitting points and the screw
5×20 on the lower fitting point.
- Place the 3 rubber inserts M5 on the ABS dashboard,
then fit the nose screen on this last one with the
remaining 3 screws 5×15 and 3 plastic washers Ø5.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
P
C
III
LA
LAINE DU
AIRE
- 1 rubber insert M5wide collar, thickness : 5mm
- 1 screw BHc 5×20 (big head)
ADAPTABLE ON GSX-S 750 2017 → ∞
« CAUTION »
FITTING INSTRUCTIONS
ERMAX NOSE SCREEN
Estimated mounting time: 30 mn
EN
Date : 12/06/17