Signs And Symbols; Device Description; Usage; Removing The Tower Fan - Beurer LV 200 Mode D'emploi

2. SIGNS AND SYMBOLS

The following symbols are used on the device, in these instructions for use, on the packaging and
on the type plate for the device:
WARNING
Warning notice indicating a risk of injury or damage to health.
IMPORTANT
Safety note indicating possible damage to the device/accessory
Product information
Note on important information.
Read the instructions
Protection class II device
The device is double-protected and thus corresponds to protection class 2
Manufacturer
Only use indoors
"Geprüfte Sicherheit" safety mark
CE labelling
This product satisfies the requirements of the applicable European and national directives.
The products demonstrably meet the requirements of the Technical Regulations of the
EAEU
Dispose of packaging in an environmentally friendly manner
20
PAP
Disposal in accordance with the Waste Electrical and Electronic Equipment EC Directive
– WEEE

3. DEVICE DESCRIPTION

Control panel
1
Handle
2
Remote control storage
3
Display
4
Ventilation grilles
5
Stand
6

4. USAGE

4.1 Removing the tower fan

1. Open the cardboard packaging.
2. Carefully pull the tower fan out of the cardboard packaging.
3. Remove all foils.
4. Check the tower fan and cable for damage. If you notice damage, contact Customer Services at
www.beurer.com.
(SEE PAGE 3)
ON/OFF button (to switch the device on and off)
7
SPEED button (to set the fan speed)
8
MODE button (to select between the 3 different modes)
9
TIMER button (to switch on and select the timer)
10
SWING button (to activate the tower fan's oscillatory movement)
11
16