Ecler NXA4-80 Notice D'utilisation page 5


RS-232 Interface

TP-NET external remote control protocol, via Ethernet and RS-232 (compatible with Crestron®,
AMX®, RTI®, VITY®, etc..)

POWER ON / OFF button and / or front panel volume controls can be deactivated by software,
preventing unauthorized tampering

Front panel volume controls are assignable to one or more audio inputs or one or more amplified
outputs

Self-diagnosis function for correct operation of the amplifier, with FAULT relay: allows the device failure
detector to switch to an external redundant system

Integrated "Anti-clip" system

Rack format (2RU)

Integrated DSP processor, configurable from EclerNet Manager. Main functions:
Each channel has a dedicated audio input mixer that enables you to generate a separate mix
o
from the ones made in the other channels
Independent controls per channel: VOLUME, MUTE, SOLO, PHASE INVERSION, MAX. VOL
o
(upper volume limit) and MIN. VOL (lower volume limit)
LP and HP crossover filters, up to 4th order, per channel
o
Bank of 8 parametric EQ filters, per channel
o
Compressor with THRESHOLD, COMP. RATIO, ATTACK, RELEASE, KNEE and MAKE-UP
o
GAIN settings, per channel
Delay, up to 1000 milliseconds, per channel
o
DUCKER function (priority): an input can be configured with highest priority, being able to
o
reduce and replace the audio content of any channel, when its signal exceeds the detection
threshold. This feature is vital in emergency / evacuation systems, which should play a specific
alarm message and / or evacuation instead of the regular audio program when detecting an
emergency scenario
5 configuration memories (presets) are available
o
* EclerNet Manager software is available on www.ecler.com.
5