Publicité
Les langues disponibles
Les langues disponibles
Index
1. Product description
2. Security advice
3. Installation
1. Product description
The Mobility Power Pack is a light weight 12 V Li-ion battery pack. It can deliver high currents and can be
used for caravan movers as a light weight replacement for a heavy lead acid battery.
The Mobility Power Pack has a built in charger. It can be charged by the supplied power adapter, but also by a
12V connection from the car or a solar panel.
2. Security advice
› It is important that you read this manual carefully
before installing and operating the Mobility Power
Pack.
› Do not connect the Mobility Power Pack with any
other battery in series to get a higher voltage.
› The Mobility Power Pack must not be connected
in parallel with other batteries or Mobility Power
Packs to obtain a higher capacity. The Mobility
Power Pack can be destroyed by the flowing
compensation currents.
› The Mobility Power Pack can only be charged by
the supplied power adapter or by the terminals. It
may not be charged by the output terminals.
› The Mobility Power Pack can deliver currents up
to 200A. The cable to the caravan mover must
be able to conduct 200A current. If you connect
an other load (such as a control lamp), you must
8
4. Operation
5. LED indications
6. Specifications
install a fuse close to the Mobility Power Pack. If
you do not use a fuse, and a short circuit occurs,
the Mobility Power Pack will not switch off and
the wires can blow and fire might occur.
› Do not short circuit the Mobility Power Pack
› Do not open the Mobility Power Pack
› Do not expose to rain
› Do not expose to temperatures above 50 °C
› Do not put into fire.
› Do not use a damaged Mobility Power Pack.
› Do not dispose of the Mobility Power Pack in the
household waste. You can return it free of charge
to the collection points in your community or to
the supplier.
3. Installation
The Mobility Power Pack can be mounted on the wall or on the floor. It must have 10 cm space around for
ventilation.
1+
2
(1+) (1-) Mount the caravan mover positive and negative on cables at the output terminals with M6 nuts. Be-
ware the correct polarity.
(2) To charge the Mobility Power Pack from the mains, connect the supplied 12VDC-1A-power adapter to the
round DCin connection.
(4a) (4b) An external push button can be connected to the terminals at
the same function as the internal push button near the LEDs (switch on/off and clearing an error).
3+
3-
4a
4b
1-
(3+) (3-) To charge the Mobility Power Pack from
the car or from a solar panel, use the "+DCin-" termi-
nal connections.
The wires must be placed through the supplied ferri-
te ring twice close to the Mobility Power Pack to
prevent radio jam during charge. Beware the correct
polarity.
This external push button has
9
Publicité
