Télécharger Imprimer la page

LG KT-OPS Série Guide De Configuration Rapide page 2

Publicité

4
Connector on the KT-OPS* /
Connecteur sur le KT-OPS* /
Connector inside the set /
Conector del KT-OPS*
Connecteur à l'intérieur de l'appareil /
Conector del interior del equipo
Open the top cover of the KT-OPS* and connect the cable provided to the connector inside the set and the connector on the
ENG
KT-OPS*.
Ouvrez le couvercle supérieur du KT-OPS* et branchez le câble fourni au connecteur à l'intérieur de l'appareil ainsi qu'au con-
FRA
necteur sur le KT-OPS*.
ESP
Abra la tapa del KT-OPS* y conecte el cable suministrado al conector del interior del equipo y al conector del KT-OPS*.
5
Screw / Vis /Tornillo
Close the top cover of the KT-OPS* and tighten it on the left and right with the two screws provided.
ENG
Fermez le couvercle supérieur du KT-OPS* et fixez-le sur la gauche et la droite à l'aide des deux vis fournies.
FRA
ESP
Cierre la tapa superior del KT-OPS* y fíjela a la izquierda y la derecha con los dos tornillos suministrados.
Top Cover /
Couvercle supérieur /
Tapa superior
6
OPS Player /
Lecteur OPS /
Reproductor OPS
Insert the OPS Player (sold separately) into the bottom hole of the KT-OPS* and finish the installation by tightening the two
ENG
screws provided on the bottom.
Insérez le lecteur OPS (vendu séparément) dans le logement situé en bas du KT-OPS* et terminez l'installation en serrant les
FRA
deux vis fournies.
Inserte el reproductor OPS (se vende por separado) en el orificio inferior del KT-OPS* y finalice la instalación ajustando los dos
ESP
tornillos suministrados en la parte inferior.
KT-OPS* INSTALLATION ENVIRONMENT
ENVIRONNEMENT D'INSTALLATION DU KT-OPS*
ENTORNO DE INSTALACIÓN DEL KT-OPS*
10 cm
10 cm
10 cm
10 cm
Attach KT-OPS* to Monitor
ENG
Fixez le KT-OPS* au moniteur
FRA
Instale el KT-OPS* junto al monitor
ESP
NOTE / REMARQUES / NOTA
Leave at least 10 cm of space at each side of the player from obstades when installing the player to ensure sufficient
ENG
ventilation.
Au moment de l'installation, laissez un dégagement d'au moins 10 cm de chaque côté du lecteur afin d'assurer une ventilation
FRA
suffisante.
Cuando instale el reproductor, deje como mínimo unos 10 cm de espacio en cada lado para permitir una ventilación adecuada.
ESP
1
2
Installation complete /
Installation terminée /
Screw / Vis /Tornillo
Instalación finalizada
10 cm
10 cm
10 cm
10 cm
Install OPS Player
ENG
Installez le KT-OPS*
FRA
Instale el KT-OPS*
ESP

Publicité

loading

Ce manuel est également adapté pour:

Kt-opsa.aau