Publicité
Les langues disponibles
Les langues disponibles
GB
Wheel brush
• The wheel brush is located inside the housing (Image XVI) and helps keep the blade
and the wheel free of sawdust and wood chips
• To adjust, loosen the screw and position the wheel brush so that it contacts the bristles
of the brush
• Retighten the screw
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs
should be carried out by an authorised Silverline service centre. This advice also applies
to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the machine's service life. Clean the body of your machine with a soft
brush, or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Troubleshooting
Problem
No function when On/Off
Switch (10) is operated
Inaccurate cut
Difficulty making straight cuts
8
Possible cause
No power
Defective On/Off Trigger Switch
Blade alignment off
Worn saw blade
Blade guide calibration is incorrect
Fence (20) is not parallel to the saw blade
Blade guide calibration is incorrect
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
Solution
Check power supply
Replace the On/Off Trigger Switch at an authorised Silverline service
centre
Re-align the saw blade as specified in 'Blade tracking'
Replace saw blade
Follow the instructions for blade guide calibration in 'Adjusting the
upper blade guide stabilising bars and blade guide bracket'
Re-align the Fence (20) as instructed in 'Using the fence'
Follow the instructions for blade guide calibration in 'Adjusting the
upper blade guide stabilising bars and blade guide bracket'
Publicité
