Termozeta Tekno NO-BAG Mode D'emploi page 14

ENGLISH
AFTER USE
• After use, press the button (14) to turn off the appliance, then disconnect the plug from
the power outlet.
• Press the button (15) to rewind the power cord: when doing this it is recommended to
accompany the power cord while it is being rewound.
• If necessary, remove the tools and release the hose * (1) from the coupling hole (13).
* To remove the hose (1) press the buttons on the tube coupling (4) and rotate it 90°
counter-clockwise, then remove coupling (4) (Fig.4)
CLEANING AND MAINTENANCE
WARNING!
Any cleaning and maintenance operation must be performed when the appliance is
switched off and the plug disconnected from the power outlet.
DUST COLLECTING CONTAINER (21) CLEANING
• Release the hose (1) by turning the coupling (4) counter-clockwise.
• Remove the dust collecting container (21) from the appliance body (10) by holding down
the appropriate release button (25) (fig. 5).
• Empty the dust accumulated in the container (21), opening the container from the bottom
and holding down the button (22) (fig. 6).
DUST COLLECTING CONTAINER (21) WASHING
• After emptying the dust container (21), remove the cover (12) by turning it counter-
clockwise.
• Remove both the dust filter (24) that the cyclonic filter (23).
• Wash the dust filter container with water, letting it dry completely, replace the filters and
reposition it in its seat (11).
For reasons of hygiene and to improve the vacuuming, clean the dust collecting
container (21) frequently.
FILTERS (19), (23) and (24) CLEANING/REPLACEMENT
Rear filter
• Remove the grid (20) on the rear of the appliance by pressing the appropriate upper tab.
• Remove the rear filter (19) from its seat.
• Wash the filter in warm water and let it dry completely before putting it back into place.
• Reposition the rid (20) on the appliance body by inserting the bottom first and then
attaching the top.