After Use - Dräger UCF 6000 Notice D'utilisation

Use
3.4.8 Stationary operation of the thermal imaging camera
(Dräger UCF 9000)
If the thermal imaging camera is to be used as a stationary device, a
tripod can be used as mounting device.
Screw the tripod into the bottom of the handle. If the crawling plate

is attached to the camera, screw the tripod into the crawling plate.
3.4.9 Opening the video player (Dräger UCF 9000)
Press the "Up arrow" button.

The functions of the video player will appear at the top of the
screen.
To select the video player functions, press the "Down arrow",

"Right arrow/laser pointer" or "Left arrow/zoom" button.
To exit the selection, press the "Up arrow" button.

46
3.5

After use

Clean and inspect the thermal imaging camera after each use (see
Chapter 5.1 on Page 49 and Section 5.2 on Page 49).
The rechargeable battery should be charged and left in the charging
cradle when not in use (see Chapter 3.2.3 on Page 40).
Dräger UCF 6000, UCF 7000, UCF 8000, UCF 9000