Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 5 screws BHc 5x20 black
- 3 silents blocs
- 3 screws FHc 4x16
- 2 aluminium paltes
- 1 plastic spacer Ø6x20x20
- 3 threaded fasteners Ø5
- 3 rubber inserts Ø4
Fitting instructions
-
Positionne the fitting brackets as the locations shown on photos 1 and 2 below:
Right side
- Place the threaded fasteners on the fitting brackets (see photos 1
& 2). Place the silent blocs on the belly pan.
- Assemble the 3 parts of the belly pan with the screws BHc 5x20
and the rubber inserts Ø5. Place the aluminium plates on the belly
pan thanks to the 3 rubber inserts Ø4 and the 3 screws FHc Ø4 (2
screws FHc Ø4 on the left side and one on the right side of the
belly pan).
4
Once fitted, the belly pan must have no contact with engine and has to be far enough
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
- 1 small head screw BHc 6x20
- 1 screw FHc 5x40
- 3 rubber inserts Ø5
- 1 ABS central part
- 4 fitting brackets
1
Plaque alu
Sabot ABS
Entretoise plastique Ø6x20x20
from complet exhaust system.
FITTING INSTRUCTIONS
ADAPTABLE ON Z900 RS 2018 → ∞
Left side
Vis FHc Ø4
- Place the entire preassembled belly pan on the motorcycle,
then screw the whole with 2 screws BHc 5x20, the screw
BHc 5x20, the screw BHc 6x20 and the spacer Ø6x20x20.
This one has to be placed between the belly pan and the
fitting bracket on the right front side of the belly pan (see
photo 4).
- Control the whole is well placed and then tighten
everything.
« CAUTION »
EN
Update : 05/11/18
ERMAX BELLY PAN
Estimated mounting time : 30 min
2
3
D
Publicité
