tau TSG Notice D'installation page 3

DIGITAL KEYBOARD TSG
Digital keyboard with remotely programmable codes (max. 50 codes) and mod. RXDC decoding receiver.
KEYBOARD INSTALLATION
● Remove the screw cover (fig. 2) with a screwdriver (fig. 1);
● after having removed the screws (fig. 3), remove the keyboard front from the battery casing;
● connect the battery to the keyboard front as shown in fig. 4;
● fix the battery casing to the chosen support (use 5 mm Ø screw anchors if fixing the keyboard to the
wall or 3.5 mm Ø self-drilling screws for metal or steel supports, or 3.5 mm Ø self tapping for wooden
or similar supports), making sure that the writing is at the top (fig. 5) so that possible condensation can
drain (1 fig. 5);
● Once the battery casing has been fixed to the support, fit the keyboard front with the battery connected
and fix it with the 2 supplied screws (fig. 6);
● Finally simply push the screw cover into place (fig. 7).
MODIFICATION OF THE MASTERCODE
The factory setting of the mastercode is: 1234.
To modify it, introduce the factory code following the sequence:
Mastercode
N.B. The new code is now memorised.
It is a good idea to note down the new Mastercode.
MEMORY RESET
The Mastercode is required in order to begin the memory reset and creation
and cancellation of a code.
The memory should ideally be reset before introducing your code. To do so,
perform the following procedure:
Mastercode
The operation is confirmed with a single long beep.
CREATION OF A NEW CODE (E.G. 1111 – PERSONAL CODE)
The codes must have a minimum of 2 and a maximum of 4 digits.
After the memory has been reset, proceed with the creation of a new code:
Mastercode
(personal code)
The operation is confirmed with a single long beep.
TRANSMISSION OF THE CODE TO THE RECEIVER
Before proceeding with the code transmission, make sure you are in the programming mode on the mod.
RXDC receiver (Press the PS1 button on the receiver – once to select channel 1 of the receiver, twice for
channel 2, three times for channel 3 and four times for channel 4 -, the red LED that corresponds to the
selected channel will light confirming that the programming phase is active), then proceed as follows:
(personal code)
The red LED on the receiver switches off confirming that the transmission has taken place.
CANCELLATION OF A CODE
Proceed as follows to cancel a code from the keyboard:
Mastercode
(personal code)
The operation is confirmed with a single long beep.
Each time a code is cancelled from the keyboard it is also advisable to cancel it from the related channel on
the receiver so as to avoid a build-up of unused codes on the receiver (max. 64 codes per channel).
N.B. If the code is introduced incorrectly the keyboard emits a double beep error signal when the
button is pushed. Repeat the correct sequence of the set code.
.
Mastercode
.
.
.
Mastercode
.
TSG
(personal code)
(personal code)
English
3