Description (Fig. A); Cleaning And Maintenance - nedis FLLMB10W Manuel De L'utilisateur

FLLMB10W / FLLMB20W
LED floodlight

Description (fig. A)

The LED floodlight is a broad-beamed, high-
intensity artificial light device equipped with a
LED lamp. The floodlight can produce bright
light without the use of expensive fixtures and
numerous bulbs. The floodlight can also provide
users with an easy and affordable way to deter
intruders and animals. The device is suitable for
both indoor and outdoor use.
1. On/off switch
2. Charging indicator
3. Charging connection
4. LED lamp
5. Reflector
6. Glass plate
7. Front cover
8. Lock screw
9. Battery
10. Locking knob (tilting angle)
11. Locking knob (rotation angle)
12. Mains adapter
13. Car adapter
Use
Charging the device
Caution!
• Before first use, discharge the battery
completely by switching on the device without
connecting it to an external power source.
• Once discharged, immediately charge the
battery for approximately 7 hours.
• Do not switch on the light during the charging
process in order to prolong the battery life.
• Fully discharge the battery at least once every
three months. Make sure that the battery
completes at least one full charging cycle every
three months in order to prolong the battery
life.
Charging indicator
Off
Red
Green
Mains adapter:
1. Connect the mains adapter to the charging
connection of the device.
2. Insert the mains plug into the wall socket.
Car adapter:
1. Connect the car adapter to the charging
connection of the device.
2. Connect the cigarette lighter plug to the
cigarette lighter connection in your vehicle.
Adjusting the tilting angle (fig. B1)
The floodlight can be tilted in an angle of 80°.
Adjusting the rotation angle (fig. B2)
The floodlight can be rotated in an angle of 360°.
Switching on and off
• To switch on the device, set the on/off switch (1)
to the "I" position.
• To switch off the device, set the on/off switch (1)
to the "O" position.

Cleaning and maintenance

Warning!
• Before cleaning or maintenance, switch off the
device, remove the mains plug from the wall
socket and wait until the device has cooled
down.
• Do not use cleaning solvents or abrasives.
• Do not immerse the device in water or other
liquids.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the
device does not operate correctly, replace it
with a new device.
• Clean the outside of the device using a soft,
damp cloth. Thoroughly dry the outside of the
device with a clean, dry cloth.
4 4
English
Description
The battery is low.
The battery is being charged.
The battery is fully charged.