Kreg Parallel Guides ACS415 Guide D'utilisation page 5

For all cuts, position the workpiece under the guide track with the waste to the outside.
ATTENTION:
(1) Position one Parallel Guide a minimum of 6" from the cord-manager
end of the guide track to allow lead-in room for the saw. Position the
second Parallel Guide 2" from the far end of the workpiece.
With the cord-manager end of the workpiece 6" from the end of the track, both Plunge Saw
ATTENTION:
tracking controls engage the guide track and the saw blade plunges into the workpiece to start the cut.
(2) Extend both tape rules to the same dimension and lock them in place.
(3) Position the guide track on the workpiece and hook the Parallel Guide
tapes on the edge of the workpiece.
The Parallel Guide tape rules are self-supporting to 96". For cuts over 48", place the guide
ATTENTION:
track with attached Parallel Guides on the workpiece in approximate position. Extend the tapes to the desired
dimension, lock them, and then reposition the guide track to engage the Parallel Guide tape hooks.
(4) Place the Saw on the Track and make the cut.
ATTENTION: After removing the Parallel Guides from the guide track, retract the tape and tighten all knobs
to prevent loss of parts.
4
3
USING THE GUIDES
1
2
1
2
3