essentiel b INCLIN'TV 32''-75'' Notice D'utilisation page 16

installation of wall plate
The screw fi xings supplied with this wall bracket are intended exclusively for fi xing to a wall
made up of solid bricks or concrete.
For installation on any other medium, please contact an approved professional installer,
and use the appropriate equipment
Insert a concrete rawl plug in each hole. If necessary, you can use a hammer to lightly tap each rawl
plug, so they are at the same level as the wall. Once the rawl plugs are in place, position the wall plate.
Attach the washers and then the lag screws into the rawl plugs which project slightly from the wall, as
indicated in the diagram below.
16 6
V.1.0 V.1.0
installation of wall plate
Begin by positioning the drilling template against the wall using the
provided spirit level to keep it straight.
Use adhesive or drawing pins to hold the template against the wall
while you drill six holes which will be used to attach the bracket.
M4x12 ou M5x12
M4x12 ou M5x12
60mm
10mm
M4x12 ou M5x12
Drill the holes with an electric drill and a 10-mm concrete bit.
Remove the template and place to one side.
M6x12 ou M8x16
M6x35 ou M8x40
!
Do not tighten completely until all
•
the screws are in place.
Do not overtighten the screws.
•
This can damage
needlessly.
Do not release the wall bracket
•
before it is fi rmly attached to the
wall.
M4x30 ou M5x3
M4x1
M4x1
M4x1
the wall