Quick KTB4 Manuel De L'utilisateur page 12

CHARACTERISTICS AND INSTALLATION
GB
KTB4
The 4-channel KTB4 interface compensates the charge of the batteries connected to the medium and high
power SBC ADV PLUS series battery chargers.
Other important advantages which the KTB4 offer, are:
• Possibility of measuring the temperature of one, two, three or four batteries (according to the number of
sensors connected).
• Possibility of connecting up to 32 KTB4 interfaces to the same battery charger.
• Universal power supply (12/24Vdc).
• CAN BUS interface for data transfer.
• Easy installation.
INSTALLATION
BEFORE USING THE INTERFACE, READ THIS INSTRUCTION MANUAL CAREFULLY.
IN CASE OF DOUBTS, CONTACT QUICK
F
In case of discordance or errors in translation between the translated version and the original text in
the Italian language, reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick®.
The KTB4 interface has been designed for the purposes described in this instruction manual. Quick® shall
not be held responsible for any direct or indirect property damage or personal injury caused by inappropriate
or unintended use of the equipment, erroneous installation or any errors that may be present in this manual.
THE WARRANTY SHALL BE VOID IF THE INSTRUMENT IS TAMPERED WITH OR ALTERED BY NON
AUTHORISED PERSONNEL.
THE PACKAGE CONTAINS: KTB4 interface - KTBS sensor - connecting cable - user's manual - conditions of
warranty.
INTERFACE INSTALLATION
The typical installation procedure is described herein. Needless to say, it is not possible to describe a
procedure applicable for all situations that may be encountered.
Adapt this procedure to satisfy your own personal requirements.
• The interface must be positioned so that it can easily be reached by the operator.
• Select a clean, smooth and flat area.
• Take special care when making the holes in the surface where the KTB4 interface will be fixed. The holes
must not weaken or cause the breakage of structural elements of the boat.
The interface complies with EMC standards (electromagnetic compatibility) but requires correct installation
to avoid compromising its performance and that of the instruments in the vicinity.
For this reason the interface must be positioned at a distance of at least:
• 25 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any SSB radio transmitters.
• 2 m away from radar beams.
12
® CUSTOMER SERVICE OR YOUR LOCAL DEALER.
KTB4 - REV002A