Kasco 2400EVX Guide D'utilisation page 20

50hz
Masquer les pouces Voir aussi pour 2400EVX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Prepare the cable and strip wire ends as shown.
Wire Stripping
4. Insert the stripped wire ends into the terminals on
the back of the Pin/Socket insert and fully tighten the
wire retention screws. (Refer to figure for correct wire
orientation).
After the wires have been connected securely, pull the
cable and insert back into the housing and tighten with
a screwdriver to ensure the insert is seated correctly.
Note: LEFT HAND THREAD, turn the insert counter
clockwise to tighten.
5. Prepare your supplied Resin Kit by removing the
cap from the resin tube and pushing the resin nozzle
onto the tube. Then twist the nozzle to lock in place.
Plunger
Before applying to the quick disconnect, use the
plunger to evenly push out a small amount of resin to
get a proper mix of of the 2-part epoxy. Then apply
resin into the housing, enough to cover the wires and
contacts. The resin should be about 3mm onto the
cord jacket. Note: Adding too much resin may cause
excess to be forced into the female end of the pin
connector, preventing proper connection of the two
halves.
4
Figure 5:
Wire Connections
Brown wire to terminal L
Blue wire to terminal N
Green/Yellow wire to terminal E
Resin Tube
Nozzle
6. Slide the gland and gland nut along the cable into
the body and tighten the gland nut securely. No drying
time is needed for the epoxy before full assembly.
7. Once the two subassemblies have been completed,
they can be joined together. Plug pin assembly into
the socket assembly and tighten the large blue nut
securely. The blue nut should be hand tightened only.
(See figure below).
Note: There is a small gap after tightening
For seasonal removal, your quick disconnect includes
an optional water tight cover. Simply separate the
quick disconnect and insert the sealing cover into the
large blue nut half and tighten firmly.
Strain Relief
The Strain Relief must be installed to protect the
Quick Disconnect from damage due to excessive
strain. The Strain Relief should be installed on the
user supplied cord length (not on the Kasco supplied
stub cord). It should be position about 15cm from the
Quick Disconnect. To install, insert the narrow end of
the elongated clamp with the chain connected into the
wide end of the short clamp. Use a rubber mallet to
tap the two pieces together securely. A Nylon Tie can
be used to keep it attached to the cord. The chain can
then be attached to the float.
Cut-Away
disconnect shown
with clear resin.
Note amount that is
covering cord jacket.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

3400evx4400evx2400ej3400ej4400ej

Table des Matières