Electrical Connection; Environmental Concerns - Zanussi ZRT623W Notice D'utilisation

Masquer les pouces Voir aussi pour ZRT623W:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
6. Unscrew the bottom far
side screw and install on
the opposite side.
10. On the opposite site,
install the hole covers pro-
vided within the accessory
bag.
1) If foreseen
Do a final check to make sure that:
•• All screws are tightened.
•• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.

Electrical connection

Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.

Environmental concerns

The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
16
7. Unscrew the top door
holding pin.
11. Tighten the hinge.
Make sure that the doors
are aligned.
8. Screw the pin back on the
other side.
12. Remove and install the
1)
handle
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
2
3
1
9. Fit the doors into the pins
and install the doors. Install
the hinge.
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.

Publicité

Table des Matières
loading

Table des Matières