Alimentation Électrique - Livington Prime EveryDay Mode D'emploi

turn the filter clockwise until you hear it click into
place. We recommend replacing the hepa filter every
6 months, or more regularly for frequent use.
REPLACING THE BATTERY (# 12)
1. Turn off the device.
2. Press the battery release button on the bottom of the
device.
3. Grasp the golden cap by the handle, and pull the
battery out of the device.
4. Insert the new battery. Make sure that the battery
clips into place.
CLEANING
Before cleaning, make sure that the device is
disconnected from the power supply and switched off.
The following cleaning recommendations for the various
components apply:
Device & storage station: Wipe with a damp, soft cotton
cloth (with water or a neutral detergent), while not
allowing water or detergent to penetrate and cause
damage.
Hepa filter (#13):
1. Tap the filter carefully, or clean it with a soft brush.
ALWAYS clean the filter after vacuuming fine dusts,
such as flour.
2. Clean the filter under running water, and allow it to
dry completely before using again. Never use a damp
filter!
Stainless steel filter: Use a damp cloth to clean the
stainless steel filter or rinse it under running water. The
filter must be completely dry before it is re-inserted into
the device.
STORAGE
Store the device in a cool and dry place when not in use. Do
not expose it to direct sunlight or moisture.
Insert the universal vacuum cleaner in the storage station
with the suction opening facing down, alongside the
crevice nozzle and the brush nozzle.
TROUBLESHOOTING
Note: If you experience any of the following problems,
please turn off the device immediately to avoid causing
further issues or damage.
Issue Problem
Battery low
No longer runs
Device switched off
Dust collector is full
Suction power
decreases Suction opening clogged
Filter clogged
M24693_M24694_M24329_M24330_livington_prime_everyday_Manual_20200923_KS.indd 11 M24693_M24694_M24329_M24330_livington_prime_everyday_Manual_20200923_KS.indd 11
Dust escapes
during operation
TECHNICAL DATA
Product category:
Nominal voltage
Charger voltage &
parameters
Battery
Weight
LISEZ LE MODE D'EMPLOI DANS
SON INTÉGRALITÉ AVANT DE
COMMENCER L'ASSEMBLAGE
ET DE METTRE L'APPAREIL EN
SERVICE.
CONSIGNES DE SÉCURITÉ
I. Merci de lire ces instructions avec attention
avec l'utilisation.
II. Merci de respecter exactement les
instructions de ce mode d'emploi, un maniement
incorrect peut provoquer des blessures et
détériorer l'appareil.
Avertissement :
Ne pas jouer avec les petites pièces de cette
boîte, toujours tenir le sac en plastique hors
de portée des bébés et des enfants - risques
Solution
d'asphyxie.
Charge battery
III. Alimentation électrique
Switch on the device using the
On/Off button 1. Merci de ne pas utiliser d'autre câble de
Empty the dust collector
2. Si le câble ou la fiche présentent des
Remove blockage
Clean the filter
11
The filter is damaged
Dust collector not inserted
correctly
Rechargeable
BLDC vacuum Product type
cleaner
Motor power
7,4V
Charging port:
USB-C Sound level
Input: 1A
2000 mAH Capacity
Continuous
520 g
operation
FR
raccord avec cet appareil.
détériorations, merci de ne plus utiliser
le produit. Adressez-vous à notre service
Switch off the device and
replace the filter
Re-insert dust collector
VC1903R
90W
≤ 65dB
300ml
12 mins
(power level 2)
17 mins (
power level 1)
23.09.20 16:49 23.09.20 16:49