Installation; Operation - Opus Technologies OP-10CH18 Manuel D'installation

OP-10CH18 | Manuel d'installation et d'utilisation | Installation and user manual |

3. Installation

Push out the two black locks on the handle in
the direction of the arrow and open the cover of
the box. Place the transceivers. Close the cover
and push the locks toward the handle.

4. Operation

4.1 Charge the accumulators of the trans-
mitters / receivers
1) Open the box.
Attention, warning, danger:
To prevent overheating of the char-
ging box, do not close the bocx while
charging!
2) Place the transmitters / receivers in the char-
ging compartments, load contacts facing down-
wards. When positioning them, be sure to fully
push the devices into the compartment so they
are securely fixed.
3) A power supply is delivered with the box
(with separate power cable), fixed in the box
with Velcro for transport. Connect the power
supply unit to the DC INPUT socket of the box
and then connect it via the mains lead to a 230
V ~ / 50 Hz socket. The operation indicator on
the power supply unit lights up.
4) To turn on the charging function, turn the
switch to ON (the switch shines).
5) As long as a charging compartment is empty,
its charging indicator flashes. When the battery
of a device is charged into a compartment, its
charge indicator lights up all the time.
6) When the battery of a device is fully charged,
the corresponding charge lamp goes out. The
device can then be removed from the charging
compartment.
7) To turn off the charging function, turn the
switch OFF (the switch turns off). If the cabinet
is not used to charge the batteries, unplug the
power supply because, even if the charging
function is off, it has low power consumption.
Note:
If a charge indicator flashes while char-
ging, the charging box performs a self
test to protect the battery.