Explanation Of Symbols On Unit - König Electronic HC-BLDPRESS21 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
11. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
LCD Display
shows battery
Low Battery
symbol
Arm or blood pressure monitor
was moved during testing
The cuff does not inflate properly
or pressure falls quickly during
testing
LCD Display
Irregular heartbeat (arrhythmia)
shows "EE"
The blood pressure monitor did
not inflate sufficiently.
The cuff was not properly wrapped
or the rubber tube was bent or
pressed.
The cuff position was not correct
or it was not properly tightened
Body posture was not correct
LCD Display
during testing
shows abnormal
result
Speaking, arm or body movement,
angry, excited or nervous during
testing
No response
when you press
Incorrect operation, or strong
button or load
electromagnetic interference
battery
Maintenance
1. Do not drop this monitor or subject it to strong impact.
2. Avoid high temperature and polarization. Do not immerse the monitor in water as this will result in damage to the
monitor.
3. If this monitor is stored near freezing, allow it to acclimate to room temperature before use.
4. Do not attempt to disassemble this monitor.
5. If you do not use the monitor for a long time, please remove the batteries.
When the cuff is dirty, detach it from the equipment, wash the cuff by hand with proper detergent and rinse in
cold water. Dry in air. Never iron.

EXPLANATION OF SYMBOLS ON UNIT

Symbol for "Caution Consult Accompanying Documents"
Symbol for "Type B Applied Parts"
CE is a kind of marking of EU safe attestation. This product matches MDD93/42/EEC
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused due to
incorrect use of this product.
SOLUTION
Change all batteries
Re-test taking care to not move your arm or the blood pressure
monitor
Ensure that the rubber tube is fully inserted into the blood pressure
monitor
People with light arrhythmia may re-test.
It is inappropriate for people with serious arrhythmia to use this
blood pressure monitor.
Review the cuff wrapping and testing sections of the instructions
and re-test.
Apply the cuff correctly and try again
Review the body posture and testing sections of the instructions
and re-test.
Re-test when calm and without speaking or moving during the test
Take out batteries for five minutes, and then reinstall all batteries.
To reduce risk of electric shock, this product should ONLY be opened by an authorized
technician when service is required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the product to water or moisture.
6

Publicité

Table des Matières
loading

Table des Matières