Watchguard Firebox M5600 Guide De Démarrage Rapide page 5

Attach the outer rails to the rack
To attach rails to the rack, align the screw heads on each end of the rail with
holes in the rack and then latch the rail to the front and back of the rack as
described below.
1. Align the front of one rail with three available screw holes in the
front edge of the rack.
2. Press the end of the rail toward the rack until the metal latch in the
center of the rail clicks into place around the inner edge of the rack.
3. Align the rear of the outer rail with three available screw holes in the
rear of the rack.
4. Pull the latch handle slightly toward the center of the rack and snap
it into place around the inner edge of the rack.
5. Repeat these steps to install the second sliding rail in the rack.
Install alternate screws on the rails
If the screw heads on the rail ends are too large to fit through the holes in
your network rack, use the eight screws with smaller heads (included with the rail kit) to replace
the screws on the rails before you install the rails in the rack.
1. Remove the outer two screws on the front of the rail and replace
them with two smaller screws included with the rail kit.
2. Remove the two screws from the back of the rail and replace them
with two smaller screws included with the rail kit.
3. Repeat these steps to install smaller screws on the second rail.
4. Install the rails in the rack as described in the previous procedure.
8
Install the Firebox in the rack
It could require two people to safely complete these steps.
1. Stand in front of the rack and hold the Firebox with its front facing you.
2. Align the inner rails on each side of the Firebox with the outer rail on each side of the rack.
3. Slide the Firebox into the rack as far as possible.
4. Slide the blue slide rail locks on the inner rails toward the front and slide the Firebox farther
Front latch
5. Use the larger screws included with the rack ears to attach the front ear brackets to the rack.
Remove the Firebox from the rack
You must release the slide rail locks to remove the Firebox from the rack. It could require two people
to remove the Firebox from the rack.
1. Remove any screws that attach the front ear brackets to the front of the rack.
Rear latch
2. Gently pull the Firebox out about half way.
handle
3. Slide the blue rail locks on the inner rails toward the front of the Firebox and pull the Firebox
Remove and replace
Remove and replace
into the rack, until the front ear brackets touch the front of the rack.
completely out of the rack.
9