Prem-I-Air EH1574 Notice D'utilisation page 4

Fix the bracket to the wall and fully tighten all screws, do not over-tighten as
•
this may damage the bracket.
Slide the fan onto the bracket then insert and tighten the thumb screw in the
•
hole at the bottom of the switch housing (10) to hold in position.
Plug the mains lead into a 13 Amp mains socket. If any other appliances are
•
connected to the same extension lead, make sure that it is rated for the total
power of all appliances connected.
If connecting via an extension lead, make sure that the lead is rated at 3
•
Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
•
Remove the remote control from the front of the switch housing by holding
•
the sides and pulling away from the body.
Use the On/Speed button on either the remote control or panel to start the
•
fan, initially the fan will operate at low speed. Press the On/Speed button to
choose between Low/Medium and High Speed. The LED's (6) will illuminate
to indicate the selected speed.
To switch Off push the OFF button.
•
The supplied remote control allows control of the On/Off, speed but in
•
addition the following extra functions are also available.
Timer: repeatedly pressing the timer button will cycle through the, 1, 2,
o
4 & 8 hour settings. At the end of the selected time the fan will stop.
For continuous operation do not touch this button. The timer can be
used in conjunction with the Modes as described below.
2840
OPERATION
7
4
3
2
1
6
5
1. Off
2. On/Speed
3. Timer
4. Mode
5. Timer Hours (1 to 8)
6. Fan Speed (Low/Medium/High)
7. Mode LED
8. Remote sensor
8
4
Ver. 2 - 04/14