Before Initial Use - Starfit 024011 Instructions Pour L'usage Et L'entretien

BEFORE INITIAL USE

If you are using the glass kettle for the first time, it is recommended that you clean your glass
kettle before by boiling a full glass kettle of water twice and then discarding the water.
OPERATION
1. When filling the glass kettle, remove it from the power base.
2. Open the lid by pressing the lid button and fill with the desired amount of water.
Always fill the glass kettle between the minimum (0.5L) and maximum (1.7L) marks.
Too little water will result in the glass kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is firmly in place before connecting the
power cord to the outlet.
3. Close the lid. Position the glass kettle on the power
base. Make sure the glass kettle bottom is completely
flat on the power base.
4. Connect the plug into a power outlet. Press the
desire temperature button located on the handle,
follow the required temperature (refer to section
operate control panel buttons). The indicator light
will turn on at which point boiling will begin. The
glass kettle will switch off automatically once the
water has boiled at your desired temperature
and the indicator light will turn off. You can shut off the power by pressing
the boil button
NOTE: Ensure that the control panel is clear of obstructions and the lid is
firmly closed. The glass kettle will not turn on if the button located on the
handle is constrained or if the lid is left open.
5. Lift the glass kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your glass kettle as boiling
water may result in severe burns. Do not open the lid when the water in the glass
kettle is hot.
6. The glass kettle will not reboil until the boil button
cool for 30 seconds before reopening to boil water. The glass kettle may be stored
on the power base when not in use.
NOTE: Ensure the power base is turned off when glass kettle is not in use.
OPERATE CONTROL PANEL BUTTONS
This glass kettle is using IC program to control heat up or keep warm water.
1. With power-on detecting function: when put the glass kettle
onto the power base, all the four indicators in the control panel
turn on and one beep can be heard. At the same time, the
indicator in the glass kettle lights up in red, green, blue in
sequence and then turns off, and the indicators in the control
panel turn off simultaneously, together with one beep heard.
2. Different colors for indicating different temperatures:
the indicator in the glass kettle will illuminate in different
colors under different water temperature at any condition.
120°F / 49°C (green), 160°F / 71°C (blue), 175°F / 79°C (purple),
195°F / 90°C (light blue), boil (red).
4
located on the handle at any moment during boiling.
is pushed on again. Allow to
Fahrenheit
120 160 175
° °
49 71 79
° °
Celcius
Boil
Bouillir Préréglage
195
° °
90
° °
-
+
Preset