Ebac Powerdri Série Mode D'emploi page 35

Using the Permanent Drainage Facility
Your dryer can be used in unattended dwellings such as holiday homes without emptying the water
container. To enable this facility you must use the permanent drainage kit supplied.
Fitting the Drainage Kit
Disconnect the Powerdri from the power supply before fitting the drainage kit.
For accessories such as the drain kit, contact your local reseller or visit www.ebac.com
34
Remove the permanent drainage seal from the rear of the unit.
To prevent this being mislaid this is attached to the rear of the panel of
your dryer.
Locate the end of the drainage tube with the bleed hole.
Push this end of the tube onto the permanent drainage outlet (it may help
to dip the end of the tube in hot water for a few seconds to soften it)
ensuring that the bleed hole is located at the top.
Ensure that the tube is securely attached to the drainage outlet and route
the pipe ensuring that:
The pipe is not kinked nor has an excessive number of bends in

it.
The level of the pipe does not rise above the level of the

machine's drainage outlet.
GB