Master DH 721 Manuel D'utilisation Et De Maintenance page 23

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
FIG.2
1. Power indicator
2. Water full indicator
3. Fan speed switch
4. Humidity controller
► Turning ON/OFF
Set the humidity controller to required
humidity level (the intensity of the humidity
extraction is increased clockwise) or 'CNT' for continuous
working.
To turn off the unit, turn the humidity controller to position
'OFF'.
► Setting ventilation speed
This dehumidifier features a twin speed fan. In normal
condition, set
the speed to
. Once you need quieter operation, set
the speed to
low position
.
►►
7. DRANAIGE
Empting the water tank
When the water tank is full or has not been positioned
well, the 'water full'
indicator will light up and the unit will shut off automati-
cally.
To move the water tank, pull it out squarely from the unit
by using the attached
handle. After empting the water tank, place the water tank
into space.
Make sure it is properly positioned, in order for the 'water
full' indicator to go out
and your dehumidifier is operational.
Continuous drainage
When the dehumidifier is operated at very high humidity
levels, the water tank
will require more frequent drainage. In this situation, it
may be more convenient
to set the unit up for continuous drainage with the fol-
lowing procedures:
1. Remove the water tank.
2. Position the spout as shown in the diagram.
* The unit will not operate without the water tank, unless
the spout is properly
positioned.
3. Place one end of an appropriately sized drain pipe over
the spout.
4. Place the other end of the pipe in a drain, ensuring it is
not kinked or coiled.
5. Ensure the water will always drain away freely and the
hose will remain in
place.
6. In very cold weather, precautions must be taken to pre-
vent the drain pipe
from 'Water full' cutout.
FIG.3
1. 'Spout for Continuous drainage
2. ‚Water full' cutout switch depressed when spout for
continuous drainage is fitted.
►►
8. MAINTENANCE
Always unplug the unit from the mains before carrying out
any
maintenance or cleaning of the unit.
CLEANING THE BODY
Use soft cloth to wipe the unit clean.
Don't ever use volatile chemicals, gasoline, detergents,
chemically treated clothes, or other cleansing solutions.
These all could possibly hurt the cabinet.
STORAGE
If not use the unit for an extended period of time. Please:
Turing the unit off, unplug and tidy AC cord.
Completely empty the water tank and wipe it clean.
Cover the unit and store where it will not receive direct
sunlight.
►►
9. TROUBLE SHOOTING
THE UNIT DOES NOT OPERATE:
Make sure the unit is plugged in.
Ensure the humidity control (or ON/OFF switch) is turned
on.
Check the water tank is positioned properly in the unit and
that it is not full.
Make sure the air inlet and outlet are not obstructed.
THE UNIT IS NOISY:
Check wether the unit is sitting on a level surface.
THE UNIT IS LEAKING:
Make sure the water collection holes on top of the water
container are not
blocked.
Ensure that the outlet from the condensate water tray,
above the water container
is not blocked.
BG
CZ
DE
DK
EE
ES
FI
FR
GB
HR
HU
IT
LT
LV
NL
NO
PL
RO
RU
SE
SI
SK
UA
SE
SI
SK
TR
UA

Publicité

Table des Matières
loading

Table des Matières