Zanussi ZRA733W Notice D'utilisation page 41

Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Water flows on the ground. The melting water outlet does not
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp
cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.
www.zanussi.com
Possible cause
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Make sure that there is cold air circu-
lation in the appliance.
1
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
2
41